Invictus V2 Variant With Shroud Heavily Weathered

The Invictus V2 – the latest in original, exclusive hilts from AusSabers.

This one off piece was made from a failed prototype colouring attempt – stripped back chemically and refinished using a combination of oxidizing and rust paint. Finished with an equally weathered Fallen Ember single wing shroud (this will be near impossible to remove without damaging the finish as the clear coat on the parts has made the fit VERY tight).

Loosely inspired by the original Invictus, this hilt has been made to be simple, yet tough. Stylish, yet comfortable.

The saber disassembles into four simple parts – the pommel, grip, switch and emitter (emitter shroud on this one will be very difficult to remove).

The emitter section features some shine through holes around the outside, all flanked by raised rings, giving the saber a slightly more industrial feel. Two holes for blade retention screws will ensure your blade is held tightly.

Underneath this, is a slightly tapered neck.

Further down, the switch segment is comfortable and smooth to hold.

The grip below it is simple – an AV Mara grip segment.

Finally, the pommel matches the holes in the emitter segment to complete the look.

Please note that due to the painted finish, this saber is not recommended for frequent and or rough handling. The paint will wear off despite our best attempts to coat it and seal it – be warned!

All installed sabers come with a blade, charge cable/external battery charger, blade retention screws and spares, as well as instructions.

Take a closer look at this saber at our video here

Length of hilt overall is 270mm. Grip is 33mm in diameter, with the slimmer grip point under the emitter at 28mm diameter.