Fallen Ember (SY01) Shroud

This is the shroud featured on the Fallen Ember (SY01) saber. Includes silver thumb screw as pictured, as well as a pointed grub screw. The shroud has a threaded hole on one side to allow for a “pressure fit” against the outside of a saber part, and a smooth larger bore hole on the opposite side to allow up to an m4 screw to pass threw and thread into an internal piece. You can even use both holes for a more secure fit where possible (Strongly recommended for duelling)

Like most Scrapyard parts, this should be compatible with most VHC saber parts (including the Scrapyard series available only from AusSabers, and our good friends at Vire Sabers USA).

Other parts are available in the hilt parts section of our shop. Please pay attention to the dimensions below to ensure this will fit your hilt!

Shroud is 106mm long and has an outside diameter of 40mm. The inner ring has an inside diameter of 33mm and will not fit any saber parts bigger than this. The inside diameter of the wings is 36mm – please keep this in mind if trying to sleeve over any saber part with varying diameter across its length.